Hello,
I am using FlexScan3D software and would like to open a project folder I was working with a few days ago. However, when I go to open the folder, it says it needs an "upconvert".
Does anyone know who to open this folder or do an upconvert?
Thanks!
Search found 4 matches
- 12 Oct 2020, 17:18
- Forum: Troubleshooting
- Topic: FlexScan3D [Needs Upconvert]
- Replies: 1
- Views: 1060
- 24 Jul 2020, 14:54
- Forum: Show your latest scan
- Topic: Smoothing too much
- Replies: 1
- Views: 777
Smoothing too much
I have a rather complicated geometry with small defects on the surface. I am using FlexScan3D to generate the 3D renderings. What I am finding is that some of the edges around the defect are far too smooth. These edges should be relatively sharp. This issue could be caused from small shadows around ...
- 20 Jul 2020, 15:34
- Forum: Show your latest scan
- Topic: Scaling Issue
- Replies: 1
- Views: 748
Scaling Issue
Hello,
I am using FlexScan3D software and it appears that each of my separate meshes have different scales. Is there a way to ensure that all of the created meshes have the same scale?
Thanks
I am using FlexScan3D software and it appears that each of my separate meshes have different scales. Is there a way to ensure that all of the created meshes have the same scale?
Thanks
- 08 Jan 2020, 01:07
- Forum: Working with scans
- Topic: Hole Filling / Capturing underside
- Replies: 1
- Views: 3041
Hole Filling / Capturing underside
Hello, I am a grad student and am scanning soft-tissue from a knee joint. I need to be able to get a full rendering of the tissue. As of right now, I have tissue sitting on top of bone but am unable to capture the underside of the tissue. I could try to use the hole-filling features but I do not thi...