3D Scan Forum

Hi, I have a home made david setup with an acer K132 and an imaging source camera. I am looking to make a better mounting setup either using 3D printed mounts or off the shelf arca-swiss style components. What is the vertical angle of the projector in the stock david setup? It appears to be fixed in...

Does anyone have a David 4 License that they would be willing to sell/trade? I am going to call HP tomorrow but I am not too optimistic about what will happen. Thanks.

I was able to split the hdmi signal going to the projector, convert it to vga and get a clean vsync pulse. The pulse was 59.6306hz incidentally (with the nominal projector frequency of 60hz) and the signal had a peak of ~325mV. The imaging source literature says that the pulse needs to be at least 3...

Hi, I realize that the scans are decent but the line problem is still an issue. I did a test with David 4 vs David 5 using the same settings and David 4 came out with what I would consider to be superior results. I have zoomed in a bit on the David 5 image but at the same scale, the David 4 result i...

I just spent the money on david 5, knowing that it may not be updated or supported in the future. I just accepted that it can be paid for in one job and that it will at least work for the next few years in the current state, until some future windows version fails to support it. I am hoping that by ...

Hi, I have not used any of the above mentioned programs but I have been looking into different options and found that many are quite expensive. One option that was particularly interesting to me is a plugin for rhino called mesh2surface. It is inexpensive and it makes sense to if you already use rhi...

Hi, this is a continuation of my post(s) from the hp forum... So I a running the following: - (1X) DMK23UX236 - computar M1214-MP2 - K132 - thinkpad x230 with onboard intel HD4000 graphics I am getting vertical ridges, particularly on surfaces that are more directly facing the camera. I have made ma...