3D Scan Forum

Mading, I use 120mm scale "inside corner". I turn the panels until cameras "see the same" - until RMS is equal. This case 0,07-0,08-ish on both. I tried the setting "Compensate angle between panels" It doesn't seem to affect RMS much but the scans aligned horribly. :?: ...

More experimenting:

20 scans on automated turntable.
Mobile-clip of the alignment.
https://www.youtube.com/watch?v=yw-N7-t6srg
(Intel i7 6700k 16GB RAM)

... resolution?

This cable lead through is about 10 cm. Sprayed with this:
https://www.3djake.uk/fabconstruct/3d-s ... ting-spray

Control Stick for a fighter aircraft. Which one? Sprayed with cyclododecane. Surface not perfect but the need for no cleaning of spray after makes it ok anyway. Number of scans is more than I wished for. Stereo mode, Manual turntable (I think I like this best. "IKEA Snudda" sprayed with ma...

A few mm offset in the left pattern? Is compensated for in the settings?

Will try to understand more this afternoon (while watching football, Sweden vs Switzerland!).
I have a couple of ball-heads for photography and am thinking about to use them for my camereas for a really
flexible setup.



M

Mading,

What happens if you turn the panel just a little clockwise?
Looks like that panel picture #2 is the camera with higher RMS Error. Correct?


M

Quick test today with homemade panel. Milled angles, 3mm glass and just office paper in the laser printer. I enlarged the 3 circles a bit and this acually decreased the RMS Error to the 0,28-range (from 0,33-0,35) 100mm scale. Then I tried to decrease distance a bit and the error increases with shor...

Quite sloppy setup today. Calibration 120 mm on HP original calibration panel. Random plastic thing painted with white PlastiDip. DIY rotary table, 20 scans, 18 degrees. AutoIt-script. Credit: https://sites.google.com/site/janbeck/3d-scanner-turntable-for-david5 Settings, RMS and algnment according ...

Again,

Received the original HP-panels today. First try att the 120mm scale.
The 6 big circles seems much bigger than the prinouts, Is this a factor in getting these (see picture)
error values?

µ and all, I havn't measured the machine itself (Old fashion Aciera F3) but it is the most acurate I (or my friends) have. I checked the finished panel with a calibrated (OK!) "angle hook". and i seems very acurate. I think we have a nice digital angle guage at work and maybe I try this on...