3D Scan Forum

I use this one: https://www.theimagingsource.com/products/industrial-cameras/usb-3.0-monochrome/dmk23ux236/ I would say that you have a USB-problem. I struggled a lot with this (actually with the Oculus Rift VR-goggles). I use USB card Inateck PCI-e to USB 3.0 (4 Ports) The big thing for me was to s...

Yes, real helmet. I used the 240mm calibration panel for the first time. RMS numbers below 0,1 (!)

2x IS-cameras with computar 12mm, Optoma ML750, and "IKEA manual turnatable". As usual

I sprayed it with AESUB blue. Not the perfect spray - i smells and it actually leaves
a bit of traces after "vanishing".

I will continue to use it, but maybe not to everything

I friend wanted a scaled down version of a flying helmet.

Scanned in one piece so obvioulsly not perfect. Printed ok.

Really nice scans of nice objects.

Testastretta Evo (?)

Thanks for showing!

Nice!

Keep up the good work


/M

Great to hear Mading!

Have I missed some pictures of your turntable (or just forgot that i've seen them)?

This thread is interesting

I bought the openscan-kit (PCB preassembled/programmed) . To fun not to try
I will modify the Arduino sketch to function with the AutoIT-solution.

Report in a few weeks I hope.

One wonders if this can (easily) be adapted to use the AutoIt-solution that i use.
From memory I need an "S" sent from the turntable on the COM-port when turning is done to trigger the next scan.

Will investigate.

/M

Tested AESUB and it works fine. It was gone over night. Cyklododekan takes longer.
The surface finish of AESUB is smoother. I will order a box of cans.

Picture for your attention