David HP 3D scan and i420 format for 4K
Posted: 07 May 2019, 14:29
Hello,
I'm building hi-res high quality setup.
As a core I do have here Panasonic GH4 and Inogeni 4K2USB3 convers the 4k hdmi into usb.
I also have here the Flea3 USB cameras - the 5MP and 12MP version. And Full-hd projector.
Unfortunately in HP 3D scan 5.6 I'm unable to get the 4K input from Inogeni working. David software is stubborn on YUYV format, and whatewer else I set in it claims cannot connect to camera and immediately restarts back to Full-HD.
So in the Inogeni I only have options for i420 and nv12 formats for the 4K resolution.
I have seen post in the forum that had it working and that could only mean that either there is a firmware for inoogeni that accepts 4K in YUYV or in the older David software the i420 was working fine. But now I'm stuck and need help.
Any ideas?
I'm building hi-res high quality setup.
As a core I do have here Panasonic GH4 and Inogeni 4K2USB3 convers the 4k hdmi into usb.
I also have here the Flea3 USB cameras - the 5MP and 12MP version. And Full-hd projector.
Unfortunately in HP 3D scan 5.6 I'm unable to get the 4K input from Inogeni working. David software is stubborn on YUYV format, and whatewer else I set in it claims cannot connect to camera and immediately restarts back to Full-HD.
So in the Inogeni I only have options for i420 and nv12 formats for the 4K resolution.
I have seen post in the forum that had it working and that could only mean that either there is a firmware for inoogeni that accepts 4K in YUYV or in the older David software the i420 was working fine. But now I'm stuck and need help.
Any ideas?