Page 2 of 2
Re: David 5 VS Flexscan3d
Posted: 01 Jun 2017, 03:00
by NARMELLA
erapip wrote: ↑24 May 2017, 12:04
Hello NARMELLA,
I'm using UI-1480-C, camera FUJINON HF12.5HA-1B (1:1.4/12.5mm). In MAX resolution the fps are low but for me is OK.
Regards,
Erald
Hi Erald ,
The shutter type of UI-1480-C is Rolling shutter and that's the cause of reduction of speed.
Can you please send some screen shot of your scanning results ?
Thanks
NARMELLA
Re: David 5 VS Flexscan3d
Posted: 29 Jun 2017, 18:31
by spark
Hello, the imaging source cameras are not supported?
-I found a screenshot in the internet from flexscan 3.1.7
https://www.dropbox.com/s/j7nyoznec3ua9 ... a.JPG?dl=0
So no chance to give it a try with imaging source / david cam?
regards, spark
Re: David 5 VS Flexscan3d
Posted: 30 Jun 2017, 14:11
by Micr0
From what I could tell 3DLMI isn't selling the software without their hardware. Their hardware uses the Point Grey cameras and the Nikon or Cannon DSLR's are used for color/texture maps. I was going to reach out to one of their VAR's and see if I could get more info and possibly a demo. I'll post if I do.
Re: David 5 VS Flexscan3d
Posted: 22 Jul 2017, 15:19
by 3dxcan
erapip wrote: ↑10 Mar 2017, 19:57
Yes, same hardware and setup. Flex is 3.1.7 that allow to costumade.
I installed 3.1.0.5, but it only allows uEye and PTgrey.