Re: David scanned by David - work in progress
Posted: 08 Sep 2017, 10:14
Your settings are nearly identical to mine, except that I use YUY2 & Disabled (adjusted within David).
All other settings are adjusted using FlyCapture before.
1) The "Quality check & Outlier removal must be adjusted to your setup (scale size, power of projector, etc...). Start low and increase until you have enough good information to build a full model by overlapping scans without holes.
2) in Flycapture, (while David is projecting a pattern !) , zoom with the mouse and fine tune fps and shutter until most stable image using absolute values. First FPS, then shutter
My procedure is for a global shutter/ mono camera !!!
3) What is your f-stop setting ?
4) Don't use gain if possible.
5) Practice on neutral item to start (simple item painted light mate grey).
Good luck
All other settings are adjusted using FlyCapture before.
1) The "Quality check & Outlier removal must be adjusted to your setup (scale size, power of projector, etc...). Start low and increase until you have enough good information to build a full model by overlapping scans without holes.
2) in Flycapture, (while David is projecting a pattern !) , zoom with the mouse and fine tune fps and shutter until most stable image using absolute values. First FPS, then shutter
My procedure is for a global shutter/ mono camera !!!
3) What is your f-stop setting ?
4) Don't use gain if possible.
5) Practice on neutral item to start (simple item painted light mate grey).
Good luck