Helmet and shoe

[DenKor]

Hello! I'm new in 3d scanning and these are some of my scans:
My hardware is: LG PF 1500G, RisingCam E3ISPM03100KPA (chinese camera from AliExpress with sony imx 256 sensor), 12mm ZLKC CCTV lens 2/3" HM1214MP5 (from AliExpress).

P.S. it's 21 scan with 24 pattern and i used fusions settings 1500 : 2
5 minutes in manual scan mode and 1.5 hours of processing. Unfortunately I have a very slow computer with AMD A6-7310 processor

[DenKor]

One more scan:

[Micr0]

One more scan:
2019-05-20_19-19-53.png
2019-05-20_19-20-05.png
2019-05-20_19-20-11.png
2019-05-20_19-20-23.png
photo_2019-05-20_19-18-45 (2).jpg
photo_2019-05-20_19-18-45 (3).jpg
photo_2019-05-20_19-18-45.jpg
Снимок6.JPG

Excellent! thanks for sharing.
Did the shiny surface of the helmet cause problems? did you use spray?

[DenKor]

One more scan:
2019-05-20_19-19-53.png
2019-05-20_19-20-05.png
2019-05-20_19-20-11.png
2019-05-20_19-20-23.png
photo_2019-05-20_19-18-45 (2).jpg
photo_2019-05-20_19-18-45 (3).jpg
photo_2019-05-20_19-18-45.jpg
Снимок6.JPG

Excellent! thanks for sharing.
Did the shiny surface of the helmet cause problems? did you use spray?

I did not use spray or surface matting. So I had some problem areas when scanning (especially in the corners due to reflection):

[mading]

Very interesting... nice job!
Seems that LG it's worth a try

[mr_cg]

Very nice!!!

Is the camera you are using monochrome or color camera?
The results are really excellent.

[DenKor]

Very nice!!!

Is the camera you are using monochrome or color camera?
The results are really excellent.

It is a colour camera with IMX265 1/1.8" SONY Exmor CMOS sensor.
I am making a new mount for camera and projector , so I hope that over time there will be more scans.