Page 1 of 1

Artec Spider - David Comparison.

Posted: 07 Feb 2020, 00:23
by Micr0
I met someone online with an Artec Space Spider and he agreed to scan a couple of hardware pieces so we could compare scans. The two pieces are, one cast iron, and one stamped steel cabinet pull. They are each about 80mm - 100 mm long. Here are screen grabs of the results:

David first:
file6.jpg
file5.jpg
file1.jpg
Artec Space Spider:
Cast Iron Deco Pull Smooth 1.jpg
Ornate Pull 2.jpg

Re: Artec Spider - David Comparison.

Posted: 07 Feb 2020, 00:29
by Micr0
Time to scan those 2 pulls including align and fuse in David: ~30min.
Time to scan both pulls with the Spider including process in Artec Studio 14: ~5min

Re: Artec Spider - David Comparison.

Posted: 07 Feb 2020, 07:14
by martan
Nice comparison!

Big difference in time!
I would scan more if it was a faster process than with my setup.

Re: Artec Spider - David Comparison.

Posted: 07 Feb 2020, 07:45
by OBNRacerMan
Despite the much faster process, Artec seemed a little weaker in quality.
And if you look at the prices of this equipment ... then I will choose David.

Re: Artec Spider - David Comparison.

Posted: 07 Feb 2020, 16:42
by Micr0
OBNRacerMan wrote:
07 Feb 2020, 07:45
Despite the much faster process, Artec seemed a little weaker in quality.
And if you look at the prices of this equipment ... then I will choose David.
My feeling too.