A friends Jaguar is to have altered gearing.
Experimenting - About to compare old and new crown wheel/pininon for Jag E-type.
This is the new parts and I must wait for the rear axle to be disassembled to scan the old parts.
Clay/Plasticine helped with alignment.
Jag
- OBNRacerMan
- Posts: 372
- Joined: 12 Aug 2019, 09:46
- Location: Obninsk, Russia
Re: Jag
Cool scans!
Soft: RangeVision DIY, Calibration panel/Rotary tables - RangeVision, Prj: LG PF1500G, Cam: Daheng Mercury MER2-630-60U3M-L (USB3.0, monochrome) x2, Obj: ZLKC FM12036MP5 (F2.8/5Mp/12-36mm) x2. And a handheld scanner Creality Ferret
Re: Jag
Helped colleague to make master for casting fishing baits:
Scanned master and made a surfacemodel (NX 12) from this.
Altered according to collegues wishes and 3D-printed.
The forum have been out of order for some days I think....(?)
Scanned master and made a surfacemodel (NX 12) from this.
Altered according to collegues wishes and 3D-printed.
The forum have been out of order for some days I think....(?)
HP 3D Scan, Optoma ML750, 2x IS DMK 23UX236 with Computar 12mm, HP calibration panel, DIY Rotary tables.
Re: Jag
Nice! Thanks for sharing.
I try to check in every other day or so and didn't notice the forum down. Maybe it was a regional internet thing?
µ
Re: Jag
There was some error so that one couldn't write private messages. I updated the forum to solve that but the update took longer than I expected. I thought that there would be some kind of maintenance message but apparently the forum goes to read only instead I will post a message next time before and after the update.