Micr0 wrote: ↑09 Dec 2020, 20:23
I meant being able to listen to a comm port and trigger off an received character.
The arduino sketch for the RV turntable works with serial input output command from/to the arduino controller.
Do you need that trigger for other purposes than the turntable?
For istance for a series of manual scan triggering from a remote control?
An arduino remote trigger connected by bluetooth / wifi?
HP 3D scan, Acer K132, LG PF50, 2x DMK23UX236, 2xComputar M1214, David Calibration panels, Melamine panels, DIY rotary table
Micr0 wrote: ↑08 Dec 2020, 18:35
Am I to assume that in RV you can do this?
Yes, marker support was one of the reasons why I switched to this software (of course, easier calibration with flat panels and the presence of an automatic turntable are also important.
P.S. And now the table can be made by yourself - they (RV) recently laid out for us the necessary information about the DIY firmware of the table to work with their program.
