Page 1 of 1
Turbo Snail scanned with Flexscan3D
Posted: 13 Mar 2021, 06:44
by Alonso
"With great power, comes great responsibility"
*Scans garden ornament*
Enjoy!
Re: Turbo Snail scanned with Flexscan3D
Posted: 13 Mar 2021, 07:50
by mading
That is really a good example for reverse engineering organic surfaces
Nice scan Alonso.
Which camera are you using? IS or a new one?
Re: Turbo Snail scanned with Flexscan3D
Posted: 13 Mar 2021, 08:04
by Alonso
Still on the IS. There has been zero interest in my cameras.
It's ok as there is obviously nothing wrong with them anyway
Re: Turbo Snail scanned with Flexscan3D
Posted: 13 Mar 2021, 16:49
by Alonso
And then we 3d print the scan, naturally!
The scan had to be modified slightly to address overhangs in a couple areas. Now it's fully printable without the use of any supports.
Re: Turbo Snail scanned with Flexscan3D
Posted: 25 Mar 2021, 19:45
by NARMELLA
Alonso wrote: ↑13 Mar 2021, 16:49
And then we 3d print the scan, naturally!
The scan had to be modified slightly to address overhangs in a couple areas. Now it's fully printable without the use of any supports.
Hi Alonso.
Was a nice result.
Is it possible to explaine more about your hardware and "flexscan3d" ?
Thanks.
Re: Turbo Snail scanned with Flexscan3D
Posted: 29 Mar 2021, 17:18
by Alonso
Narmella,
FlexScan3D is the software I'm using instead of HP/David-3D.
Hardware wise I'm using IS 3.1mp cameras with global shutter, 12mm lenses, 1080p dlp projector