Worm gear reducer

What have you scanned recently?
Post Reply
SilverGhost
Posts: 11
Joined: 07 Mar 2017, 07:47

Worm gear reducer

Post by SilverGhost »

The screws are shiny so they are not on the scan, like the output shafts are. They make no benefit so I just let david to patch them during fusion. Scanned with acer k135i + nikon d3300.
Attachments
2017-04-14_11-57-47.png
Curiousjeff
Posts: 121
Joined: 16 Nov 2016, 22:31

Re: Worm gear reducer

Post by Curiousjeff »

Nice surface and fusion.

How are you using the Nikon with David?


Jeff
SilverGhost
Posts: 11
Joined: 07 Mar 2017, 07:47

Re: Worm gear reducer

Post by SilverGhost »

Thanks! With the calibration boards made of mirrors and oracal printed film on them, the alignment and fusion became real simple and nice.

I use Nikon via blackmagic shuttle usb3.0.
User avatar
Micr0
Posts: 586
Joined: 15 Nov 2016, 15:20
Location: New York City

Re: Worm gear reducer

Post by Micr0 »

Nice!. Looks like a very accurate scan.
µ
erapip
Posts: 56
Joined: 16 Dec 2016, 07:16

Re: Worm gear reducer

Post by erapip »

Nice results!
What lens do you use? What about camera parameters, f-stop, ISO, aperture, etc?
Can you show a live capture image of the scene?

Thanks!
SilverGhost
Posts: 11
Joined: 07 Mar 2017, 07:47

Re: Worm gear reducer

Post by SilverGhost »

The lens is nikkor 18-105 at a little bit more than 35mm. 1/30 sec, iso 400, f13, monochrome preset with sharpness set to +6, 1080p 30 frames/sec, all enhacers like d-lightning, denoise etc. shut off, wb set to flash preset. Now I can not show you the live scene 'cause the scanning is already done.
SilverGhost
Posts: 11
Joined: 07 Mar 2017, 07:47

Re: Worm gear reducer

Post by SilverGhost »

here is the fusion result of 8 scans of the crown drill. needed to scan it's teeth to find out what is the angle of sharpening. The setup is nikon d3300 via blackmagic and acer k135i. The roughness on the bottom is the rust

P.S. the diameter of drill is 49мм
Attachments
2017-08-17_15-23-24.png
2017-08-17_15-22-49.png
3dscanner
Posts: 13
Joined: 21 Aug 2017, 09:51

Re: Worm gear reducer

Post by 3dscanner »

Hi SilverGhost!
Can you show the calibration board.i can not image the mirrow and oracal printed film.thanks!
Post Reply