Scanning van interior
Posted: 17 Dec 2018, 09:59
Hi all,
I don't own a 3d scanner (yet). I have messed a bit with the kinect (5 years ago, and it was cool). I have read a lot and seen a lot of different scanners (on the internet).
I am a carpenter and I would like to scan the interior of a van for measurements. I design my work in sketchup or fusion 360. I would like to be able to import my scan in any of those packages and use it as a reference.
I really don't know what scanner I should make/buy. Any advice would be welcome.
New to my options is Lidar. I saw some cheap Chinese Lidar devices. Is Lidar something that could be used for this?
It does not have to be super precise. Around 1mm would be sufficient. Easy/fast to setup. Not to expensive to buy/make.
Did I forget something?
Thanks in advance.
Aaron
I don't own a 3d scanner (yet). I have messed a bit with the kinect (5 years ago, and it was cool). I have read a lot and seen a lot of different scanners (on the internet).
I am a carpenter and I would like to scan the interior of a van for measurements. I design my work in sketchup or fusion 360. I would like to be able to import my scan in any of those packages and use it as a reference.
I really don't know what scanner I should make/buy. Any advice would be welcome.
New to my options is Lidar. I saw some cheap Chinese Lidar devices. Is Lidar something that could be used for this?
It does not have to be super precise. Around 1mm would be sufficient. Easy/fast to setup. Not to expensive to buy/make.
Did I forget something?
Thanks in advance.
Aaron