CAD / Scan Inspection Software

Use this section to get into contact with manufacturers and vendors. Manufacturers can update you here about their latest tools. Posts in other subforums that have advertising character will be moved here or deleted.
Post Reply
Jim Juraev
Posts: 1
Joined: 21 Apr 2017, 08:25

CAD / Scan Inspection Software

Post by Jim Juraev »

Hello All,

Briefly, I would like to share the release of New Inspection Software, PointShape Inspector in South Korea.

The Key Features are as the following:
- Best Fit (Scan to CAD), RPS, Datum Alignment
- Mesh Creation
- Deviation : whole / section / point
- Native CAD Format Support
- CAD to Mesh
- Measurements
- Report Creation: PDF

The video of introduction:

Thanks for attention.
section comparison1.png
whole comparison3.png
Posts: 307
Joined: 31 Jan 2017, 13:09

Re: CAD / Scan Inspection Software

Post by mading »

Gom inspect
LG PF50, LG PF1500, RangeVision DIY: 2x DahengMer630, 2X12 and 2X16 mm 5Mp ZK lenses, RV turntable
Post Reply