CAD / Scan Inspection Software
Posted: 21 Apr 2017, 08:39
Hello All,
Briefly, I would like to share the release of New Inspection Software, PointShape Inspector in South Korea.
The Key Features are as the following:
- Best Fit (Scan to CAD), RPS, Datum Alignment
- Mesh Creation
- Deviation : whole / section / point
- Native CAD Format Support
- CAD to Mesh
- Measurements
- Report Creation: PDF
The video of introduction: https://www.youtube.com/watch?v=GmhP7bUXknI
Website: http://pointshape.com/inspector/
Thanks for attention.
Briefly, I would like to share the release of New Inspection Software, PointShape Inspector in South Korea.
The Key Features are as the following:
- Best Fit (Scan to CAD), RPS, Datum Alignment
- Mesh Creation
- Deviation : whole / section / point
- Native CAD Format Support
- CAD to Mesh
- Measurements
- Report Creation: PDF
The video of introduction: https://www.youtube.com/watch?v=GmhP7bUXknI
Website: http://pointshape.com/inspector/
Thanks for attention.