Page 1 of 1

CAD / Scan Inspection Software

Posted: 21 Apr 2017, 08:39
by Jim Juraev
Hello All,

Briefly, I would like to share the release of New Inspection Software, PointShape Inspector in South Korea.

The Key Features are as the following:
- Best Fit (Scan to CAD), RPS, Datum Alignment
- Mesh Creation
- Deviation : whole / section / point
- Native CAD Format Support
- CAD to Mesh
- Measurements
- Report Creation: PDF

The video of introduction: https://www.youtube.com/watch?v=GmhP7bUXknI
Website: http://pointshape.com/inspector/

Thanks for attention.

Re: CAD / Scan Inspection Software

Posted: 11 Aug 2018, 10:50
by mading
Gom inspect