FlexScan3D [Needs Upconvert]
Posted: 12 Oct 2020, 17:18
Hello,
I am using FlexScan3D software and would like to open a project folder I was working with a few days ago. However, when I go to open the folder, it says it needs an "upconvert".
Does anyone know who to open this folder or do an upconvert?
Thanks!
I am using FlexScan3D software and would like to open a project folder I was working with a few days ago. However, when I go to open the folder, it says it needs an "upconvert".
Does anyone know who to open this folder or do an upconvert?
Thanks!