Page 1 of 1

FlexScan3D [Needs Upconvert]

Posted: 12 Oct 2020, 17:18
by kate_Jelaine

I am using FlexScan3D software and would like to open a project folder I was working with a few days ago. However, when I go to open the folder, it says it needs an "upconvert".

Does anyone know who to open this folder or do an upconvert?


Re: FlexScan3D [Needs Upconvert]

Posted: 22 Feb 2021, 03:11
by Popex
Hello! you need to upconvert why the project was performed with a version older than the one you currently have. greetings from Argentina!