Page 1 of 1
Revopoint Mini with dual axis turntable
Posted: 08 Sep 2022, 03:58
by gtcnetworking
Hi I have just purchased a Revopint Mini with a dual axis turntable. Has anyone been able to get the two to work ?
The software says you have to update the firmware before it will work, but when you try to do that. it just hangs.
From other forums I have found the firmware has not even been released yet.
Is this true ?
Is Revopoint selling dud gear that DOES NOT WORK !
Never again!
Re: Revopoint Mini with dual axis turntable
Posted: 08 Sep 2022, 06:46
by OBNRacerMan
Hi. I don't see anything wrong... I think they just sell equipment in advance. And those who bought it now after a while will receive full functionality after the release of the corresponding firmware.
But, since I don't have a Mini, I don't know if they warned me in advance about this moment.
Re: Revopoint Mini with dual axis turntable
Posted: 08 Sep 2022, 11:02
by Micr0
gtcnetworking wrote: ↑08 Sep 2022, 03:58
Hi I have just purchased a Revopint Mini with a dual axis turntable. Has anyone been able to get the two to work ?
The software says you have to update the firmware before it will work, but when you try to do that. it just hangs.
From other forums I have found the firmware has not even been released yet.
Is this true ?
Is Revopoint selling dud gear that DOES NOT WORK !
Never again!
Are you having trouble with the scanner or the turntable?
Re: Revopoint Mini with dual axis turntable
Posted: 29 Sep 2022, 06:11
by zhuixunyiyi
Hello, you can download the new version Revo Scan V4.1.0 to control the Dual axis turntable.
Download address:
https://www.revopoint3d.com/download/