Hi
Tibor
Hunka Tibor hardware
- Hunka Tibor
- Posts: 11
- Joined: 14 Nov 2016, 17:37
Re: Hunka Tibor hardware
Hi Tibor,
Are you using David 5 for dual camera? Any luck with it?
Are you using David 5 for dual camera? Any luck with it?
- Hunka Tibor
- Posts: 11
- Joined: 14 Nov 2016, 17:37
Re: Hunka Tibor hardware
Hi
After pause, broken leg, mystical thrombosis, I'm again active.
http://forum.hobbycnc.hu/uploaded_image ... 635_98.jpg
http://forum.hobbycnc.hu/uploaded_image ... jbb_98.jpg
Tibor
After pause, broken leg, mystical thrombosis, I'm again active.
http://forum.hobbycnc.hu/uploaded_image ... 635_98.jpg
http://forum.hobbycnc.hu/uploaded_image ... jbb_98.jpg
Tibor
Re: Hunka Tibor hardware
I see you are using some kind of coded targets, what other meteorology system do you use in addition to david which uses those targets?
- Hunka Tibor
- Posts: 11
- Joined: 14 Nov 2016, 17:37
Re: Hunka Tibor hardware
Photogrammetry software uses these signals, but I'm actually starting to use it. If I get results I'll publish it.