Flexscan3D with IS cameras

[mading]

Great job Martan!

[Micr0]

Great job Martan!

Nice.
Do you have a triumph or BSA to go with that Amal?

Keep us posted with your thoughts.

[martan]

Tried a bit more and I some scans are very striped.

Tried different shutterspeeds from 1/60 down to 1/27. No change.

Any Ideas?
These scans are without any changes in the settings at all.
Just pressed the scan button a few times and the scans turns out good sometimes and bad sometimes.

(
The carburettor belongs to a friend with a few old english motorcycles. One is a BSA Rocket I think.
)

[mading]

I got similar defects.
Tried once, but got less problems over 160 (ms?)

[Micr0]

Make sure you are not shaking the table with the carb on it or the cameras.

[martan]

@Mading, What setting are you referring to ? The 160ms.

@µ - nothing moves

[mading]

@Mading, What are you referring to ? The 160ms

The number you see when you select "advanced" Above the cameras.
I got no data unless I increase above 160 (or whatever I don't remember).
If you press "Estimate" Gives you the theorethical syncro delay (I guess). Gave me 60: no data, only occasionally. If I increase the parameter data progressively appear.

[martan]

Thanks Mading!

The text is missing on those figures. Seen them in the manual.
Button "Estimate" gav me different numbers frpm 50 to 170. Can't say I saw any effect.

Made a new calibration panel and was a bit more thorough when calibrating and now it seems to work.

Any one had the energy to look at a DIY rotary table solution?

[Alonso]

Any one had the energy to look at a DIY rotary table solution?

I'm researching that right now. No clue when I'd have something actually useful to share though...

[martan]

@Alonso

What is yor aproach to the rotary table?
I see three scenarios:

Use one of the existing plugins and new Arduino code
Make new plugin from example
Make new plugin from example AND new Arduino code