CAD / Scan Inspection Software

If you produce / sell / support 3D-scanners commercially please feel free to present your products and attainable results in this subforum. Posts in other subforums that have advertising character will be moved here or deleted.
Post Reply
Jim Juraev
Posts: 1
Joined: 21 Apr 2017, 08:25

CAD / Scan Inspection Software

Post by Jim Juraev » 21 Apr 2017, 08:39

Hello All,

Briefly, I would like to share the release of New Inspection Software, PointShape Inspector in South Korea.

The Key Features are as the following:
- Best Fit (Scan to CAD), RPS, Datum Alignment
- Mesh Creation
- Deviation : whole / section / point
- Native CAD Format Support
- CAD to Mesh
- Measurements
- Report Creation: PDF

The video of introduction:

Thanks for attention.
section comparison1.png
whole comparison3.png

Posts: 144
Joined: 31 Jan 2017, 13:09

Re: CAD / Scan Inspection Software

Post by mading » 11 Aug 2018, 10:50

Gom inspect
HP 3D scan, Acer K132, LG PF50, 2x DMK23UX236, 2xComputar M1214, David Calibration panels, Melamine panels, DIY rotary table

Post Reply