33UX264 camera, advice needed

Discuss about cameras, projectors, calibration panels, turntables etc.
Post Reply
Posts: 5
Joined: 18 Mar 2019, 22:42

33UX264 camera, advice needed

Post by hornetitou » 21 Mar 2019, 19:49


I use david scanner V3 to do some reverse Engineering of mecanical parts.
the parts are mainly gearboxes parts as selection forks, pinions, alloy casing and parts with a volume from 50x50x50 to 500x500x500mm max.

I already have a K137 projector with the lever modified
A logitech C615 modifyed to mount lens on it

I have a schneider variogon
aperture: f/1.8 to f/16
Focal Length: 12.5-75mm
suitable for sensor of 2/3" CCD
more here :
https://www.bhphotovideo.com/c/product/ ... mm_to.html

I want to invest in a more accurate solution and I found this camera:

2,448×2,048 (5 MP) sony CMOS Pregius IMX264LLR
38 fps
global shutter
sensor: 2/3 inch
USB 3.0

is it a good camera?
is it not too much overill?

Thanks for your advice

Best regards

Post Reply