A Few Hardware Scans

What have you scanned recently?
Post Reply
User avatar
Micr0
Posts: 264
Joined: 15 Nov 2016, 15:20

A Few Hardware Scans

Post by Micr0 » 31 May 2018, 18:57

I found some old hardware in an Antiques store a couple weeks back. Here are some of the scans:

A Cast Iron Cabinet pull Calibrated at 120mm. The pull is ~80mm tall.
Decco Pull1.jpg
Decco Pull2.jpg
More Later
µ

erapip
Posts: 41
Joined: 16 Dec 2016, 07:16

Re: A Few Hardware Scans

Post by erapip » 02 Jun 2018, 22:14

As always Micr0 beautiful scans :P
What is the purpouse of it?
Im sharing one of my last scan. Hope you like it.
Regards
Attachments
IMG_20180601_200015_186.jpg

User avatar
Micr0
Posts: 264
Joined: 15 Nov 2016, 15:20

Re: A Few Hardware Scans

Post by Micr0 » 06 Jun 2018, 11:02

erapip wrote:
02 Jun 2018, 22:14
As always Micr0 beautiful scans :P
What is the purpouse of it?
Im sharing one of my last scan. Hope you like it.
Regards

Great clarity! Very nice detail. Just curious, have you checked your dimensional accuracy? Are you parts measuring in David what they are in the "real" world?

These scans(I will post a few more), are of cabinet hardware. The handles one uses to open cabinet doors.
µ

illbefucd2
Posts: 3
Joined: 26 Feb 2018, 06:18

Re: A Few Hardware Scans

Post by illbefucd2 » 08 Jun 2018, 08:25

Hi to All,
this is probably a very dumb question as im only very new here
But how do we measure in david the accuracy or how do we measure the scan.

Thanks in advance

User avatar
Micr0
Posts: 264
Joined: 15 Nov 2016, 15:20

Re: A Few Hardware Scans

Post by Micr0 » 08 Jun 2018, 11:25

illbefucd2 wrote:
08 Jun 2018, 08:25
Hi to All,
this is probably a very dumb question as im only very new here
But how do we measure in david the accuracy or how do we measure the scan.

Thanks in advance
I'm assuming you are using version 5 of David In that there is a measure feature with which you can click on 2 points and David will give you the distance between them. You can then compare that to measurements you do on the scan subject in the physical world. Say measuring between two machined faces on a casting with a caliper or micrometer etc.
µ

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests